Heating
Furnace repair in Pueblo
A furnace that won't light, won't stay lit or won't stop running. Call and an independent heating contractor can talk it through and arrange a visit.
Signs worth a repair call
One cold morning after a power blip can be a reset. A pattern is different. These are the ones to mention on the call:
- The blower runs but the air from the registers is cool.
- The burners light, then shut off a few seconds later, over and over.
- You hear the igniter click or see it glow, and nothing catches.
- Flames look yellow and lazy instead of steady blue.
- The furnace trips its breaker or blows a fuse.
- A new smell, rattle or squeal shows up with the heat.

Three checks before you call
- Set the thermostat to heat, a few degrees above room temperature, and replace its batteries if it uses them.
- Pull the filter. A filter packed with dust can starve the furnace of air until a safety switch shuts the burners off.
- Find the switch near the furnace, which looks like a light switch, and the breaker. Make sure the front panel is pressed fully home, because many furnaces won't run with it loose.
If those three are fine and the house is still cold, the fault is inside the cabinet.
What a technician usually looks at
Modern gas furnaces run through a sequence: the draft fan starts, a pressure switch confirms venting, the igniter heats, gas flows, a sensor proves there is flame, then the blower comes on. A repair visit follows that sequence to find where it stops.
- Flame sensor coated with residue, so the board shuts the gas off.
- Hot-surface igniter cracked or worn out.
- Pressure switch or its tubing, often tied to a blocked vent or a full condensate trap.
- Draft inducer motor, blower motor or a run capacitor.
- High-limit switch tripping because airflow is choked.
- Control board fault codes, read from the blinking light inside the cabinet.
What moves the cost of a repair
Whether the part is stocked, how easy the furnace is to reach, how old the model is, and whether the fault traces back to something else, such as a vent pipe or ductwork. Ask the contractor to explain the finding before agreeing to the work.
If you smell gas
Don't touch switches or the thermostat. Get everyone outside, call 911 from there, then call the gas utility's emergency number printed on your bill. The City of Pueblo lists Xcel Energy as the gas company inside the city.
Questions
Can one call cover the furnace and the AC?
Yes. In a ducted system the AC shares the furnace blower and ductwork, so heating contractors commonly work on both.
Will the contractor need to go in the crawlspace or attic?
Sometimes. Say where the furnace sits when you call, so the visit is planned around the access.
Does a repair need a permit?
Ordinary part swaps usually don't. Replacing the furnace does, through the city or county building office for your address.
Where these facts come from
Cold house, warm house, or a system you're unsure about?
Call and describe what the furnace or air conditioner is doing. You'll be put through to an independent HVAC contractor who works in Pueblo, and the two of you take it from there.